Fun Wiring A Fan Light With Two Switches

Cap it off using a wire nut and secure with electrical tape.

Wiring a fan light with two switches. Connect the black wire coming from the lightbox with the black wire leading to the second switch by twisting their ends together and fastening with a third wire nut. Connect a black wire from the ceiling to the black wire from the fan. The red wire is spliced to the output on the.

You will then want to connect your remaining hot wire to the receiver again using a wire nut and electrical tape. Take the white wire leading to the second box and mark its end black too. The source is at the switches and the input of each is spliced to the black source wire with a wire nut.

At the switch box the black wire is splice to the output on the speed controller and at the other end to the black fan wire. Connect the red wire leading to the second switch to the top brass screw on the right side. Connect the second black or red wire coming from the ceiling to the blue wire coming from the fan.

Connect it to the screw on the left side of the switch. You need to cap off one of them because in a remote control fan you only need one hot wire. The hot wires are either black or red the white wires are neutral and the bare one is the ground wire.

Connect the 2 ground wires with a fourth wire nut. Wrap electric tape around the connection points and then attach wire. For instance if a module is usually powered up also it sends out a new signal of half the voltage and the technician does not know this he d think he has an issue as this individual would expect the.

Attach the neutral wires together and place the bare wire around some of the metal of the bracket in the ceiling. You can install a canopy mounted control fan on a dual switch system however the second switch will no longer function. From the switches 3 wire cable runs to the ceiling outlet box.