Ace Wiring Up A Double Light Switch

To switch from two locations youll need 2 two way switches and wire them together in a particular way.

Wiring up a double light switch. Though it is not difficult to wire a double switch careful attention to safety is crucial to prevent injury. Look at the terminals on the double gang switch. For example you might want to turn on a bathroom light separately from the ceiling fan.

The white or neutral wires bypass the switch so the one coming from the power source and the one from the light get spliced and capped in the box. The ground wire on the other hand must connect to both switches and the easiest way to do this is. Step by step.

The next length of the twinearth cable will run from the light to the first two way switch. Connect the three ground wires together along with a pigtail with a wire connector wrap it with electrical tape and stuff it back into the box. The white or neutral wire bypasses the switch and goes straight to your lights.

The ground wire sometimes in a green jacket should be connected to your switch and to your lights. When you are finished it is a good idea to wrap the switch with electrical tape to cover the connections. 3 way light switch wiring 2 wire system this switch arrangement is basically two two way switches on a single face plate.

In position 2 when the switch is up or off com and l2 are connected together. The pigtail gives you two hot wires instead of just one. Double switches sometimes called double pole allow you to separately control the power being sent to multiple places from the same switch.

On one side you should see two screws connected by a small piece of metal. To wire a double switch you ll need to cut the power remove the old switch then feed and connect the wires into the double switch fixture. This wire is needed to complete the circuit.