Looking Good Dimmer Switch Ground Wire

Press a grounding clip and 6 in.

Dimmer switch ground wire. Use a screwdriver to press the metal grounding clip and bare copper wire 6 inches to the grounded metal box. Cut away a little bit of drywall under the box to provide clearance for the clip. I show how to install a single pole dimmer switch.

The process of installing a dimmer switch for led is the same as that of installing a switch. Cut a little section of the drywall beneath the box so as to provide a way for the clip. The steps are basically the same for how to install a switch.

Once you have installed the ground wire wrap one of the remaining dimmer wires around either the black or white cable wire once again letting the dimmer wire extend beyond the cable by about one eighth of an inch. Length of bare copper wire onto the metal box with a screwdriver. This enerlites dimmer can be used as a single pole or 3 way dimmer switch.

Repeat with the last two wires cover them with a cap and twist until tight. The ground wire is typically green or copper and should be connect to the bottom center wire on your dimmer. Use a plastic wire cap to secure the two wires after wrapping protecting the.

The requirement for grounding is located at 404 9 b of the nec and states that snap switches including dimmer and similar control switches should be connected to an equipment ground conductor it further says that the switch shall provide a means to connect metal faceplates to the equipment grounding conductor. Make sure the alligator clips do not touch the bare ground wire or the metal device box. Slip on a wire nut and twist until tight.